Anylogic vs. JuliaSIM vs. SimScale

For a small company, SimScale is a great fit. It allows me to gain the use and support of higher-end software analysis on demand without the traditional high cost. This is super convenient for a company that does occasional design and analysis. Since the computing is cloud-based it also allows me to process large and detailed models without the high hardware cost that can be required. One potential drawback is that the design information is stored on someone else's server. For some industries and companies this would be a deal-breaker.

Incentivized

• Material non-linear analysis.
• Geometric non-linear analysis.
• Meshing.

Incentivized

• Learning from tutorials is great, but limiting. The online help is a must.
• Some simulations take a lot of time, but at least it's not on your PC.
• Sometimes the software times out due to the server.

Incentivized

I had a great experience with SimScale but we only used the software for a short period of time to complete the current design requirements. It is not a software that we would continually subscribe to. Next subscription event would occur when there is a design requirement to do so.

Incentivized

SimScale is much faster to spin up on than OpenFOAM. Ansys CFD tools are much more expensive! Both tools require expensive computing equipment to run, which SimScale does not!

Incentivized

• It has allowed us to increase our service offering which has lead to additional work.

Incentivized